100 Tips in decoration construction

1、 Water and electricity 1. Waterproof construction should adopt film waterproofing. 2. Waterproof works should be done after the construction of concealed works is completed and accepted. 3. Water storage tests should be done twice after the completion of waterproof construction. 4. The waterproof layer of the bathroom should not be less than 1.8 meters. 5. The floor drain, internal and external corners, pipelines and other places should be waterproof once more. 6. The floor drain should use odor proof floor drain. 7. Hot and cold water pipes should be hot on the left and cold on the right. 8. Water pipes should not walk from the ground as far as possible. 9. Cold water pipes should have a 1cm protective layer in the wall, The hot water pipe is 1.5

I. water and electricity

1. Film waterproofing should be used for waterproof construction

2. Waterproof works should be done after the construction and acceptance of concealed works

3. After the completion of waterproof construction, two water storage tests should be done

4. The waterproof layer of bathroom should not be less than 1.8 meters

5. Floor drains, Yin Yang corners, pipelines and other places should be waterproof once more

6. Floor drains should be deodorized

7. Cold and hot water pipes should be hot left and cold right

8 Try not to walk the water pipe from the ground

9. The cold water pipe should have a 1cm protective layer in the wall, and the hot water pipe is 1.5cm, so the groove should be opened deeply

10. When installing the PPR pipe, we should consider the thickness of the ceramic tile, so that the pipe will not be exposed

11. Cooking is only a few minutes, and it takes a long time to wash the vegetables. We must buy a large water bucket

12. The faucet and basin should be matched, and it can't be installed if it's not done well

13. Cement can't be used for toilet installation, Silica gel should be used

14. Pay attention to protection after the toilet and faucet are installed

15. When buying the toilet, consider the pit distance of the toilet

16. The washing machine should consider whether it is upper drainage or lower drainage

17. It is best not to install a telephone in the bathroom, which is prone to moisture

18. The size of the mirror in the bathroom should be considered first, otherwise the front light of the mirror is easy to be installed high

19. It is best to leave an access hole in the bathroom pipeline

20 Strong current and weak current cannot be threaded in the same pipe

21, left zero and right phase grounding

22, the power socket is 300 away from the ground, and the switch is 1.4 meters

23, the switch should not be installed behind the door

24, the socket should be good

25, 16a sockets for high-power appliances, such as electric ovens

26, good

27, the cassette must be matched with the panel, otherwise it may not be installed

.28 The cross-sectional area of the wires in the PVC conduit shall not exceed 40% of the cross-sectional area of the conduit

29. The air conditioner in the bedroom should not face the bed

30. The air conditioning hole should be considered to tilt outward, otherwise the rain will come in

31. The lamp should be considered to be dual control

32. It is best to install a splash proof socket in the bathroom

33. A socket should be considered on the balcony

34. The wire trough should be horizontal and vertical, and the lighting should be arranged well. It is convenient to use in the future

35 Check valves should be installed in the public flue

36. The purchased electrical appliances must be well let the workers read the instructions

37. The instructions, warranty cards and other materials must be kept well

II. Bricklayers

38. The cement cannot be used after three months of the delivery date

39. Cement of different varieties and grades cannot be mixed

40. Yellow sand must be used. You can taste it with your mouth

41. Wall and floor tiles must be soaked in water for more than two hours, After drying in the shade, you can paste

42. You'd better buy more pieces of wall and floor tiles instead of less, otherwise it's easy to have color differences

43. There can't be two rows of non whole tiles on one wall

44. After the joint is wiped, you should immediately clean the tiles

45. The ground should be pasted with marble (light color), and the back of the stone should be waterproof

46. The external corner should be cut at a 45 degree angle

47. The floor tiles should be inclined to the floor drain, otherwise it's easy to accumulate water

48 When the wall tile touches the pipe opening, it should be cut in the form of casing, so it still looks like a whole brick

49. The ground marble should be dry paved

50. The floor tile must be dirt resistant and anti-skid. Don't just look good

51. Matte tiles are difficult to clean

52. The balcony floor tile should pay attention to the drainage direction

III. carpentry

53. The floor keel is best to use dried larch

54. After buying large wood, you should cut it and dry it

55 Carpenters should first snap the horizontal line of the house before entering the site

56. The decor panel should be painted once as soon as it comes in to prevent it from getting dirty

57. The ceiling fan should not be installed on the ceiling keel

58. During the construction of the decor panel, the color should be selected in advance

59. The hanging bar of the ceiling should not be more than 300

60 from the wall. The gypsum board should be fixed with countersunk self tapping screws, 1~2mm into the board surface, and should be treated for rust prevention. Gun nails

61 The distance between the nails of the gypsum board should not be greater than 200

62. The gypsum board should have a 3mm joint with the wall for crack prevention treatment

63. The external corner of the gypsum board should be protected by external corner strips

64. The upper and lower risers of the wooden door should be painted

65. The bottom of the bathroom door cover should be painted with waterproof

66. The size of the door should be the same

67. Furniture should not be made by woodworkers as far as possible, and those that cannot be done well

68 Try to buy the whole cabinet. If the carpentry is not good, the design is not good

69. The medium size must be considered well, and it will be troublesome to change it.

70. Don't make a dark track for the sliding door you make, and if you can't repair it later.

71. If the bathroom is small, try to make a sliding door, don't open the door, take up space

72. If you can't eat carpentry, you must communicate more with the foreman, and don't let them make their own ideas

73 Money is the last word in your hand

74. There are children at home, and you should use less glass

75. You must let the workers look at the drawings carefully

76. Kitchen drawers are very useful

77. The flatness of the wooden dragon bone on the floor is 5mm

78. The rough floor should be paved at 30 degrees or 45 degrees. Leave 2 ~ 3mm between the boards, and the seams should be staggered

79. Leave 8~10mm seams between the floor and the wall

80. When the length of the composite floor exceeds 8m, you should consider expansion joints

81 Try not to use MDF as door pocket

82. Hinges and hardware must be used well

83. Yuba should be installed on the wooden keel, not directly on the ceiling

IV. oiler

84. Try not to mix water in the construction of medium and dark latex paint, otherwise it is easy to have color differences

85. Plaster board joints should be bandaged

86. It is better to put cool cloth on the cracks on the wall

87 It is best to remove some putty on the original wall, or brush it with glue for sealing

88. Try to buy paint of well-known brands, and try not to use paint recommended by the decoration company or the foreman. If the weather is too wet, do not brush paint

90. Polish the paint and coating after it is completely dry.

91. The next paint construction must be carried out after the previous paint is completely dry.

92 Antirust treatment should be done for the paint on the metal surface

93. The weather is too cold, and the paint construction quality will be poor

94. When painting the door, stick the hinge and door lock with masking paper

95. When it is too hot, pay attention to ventilation

96. When pasting wallpaper, brush clear oil on the wall

97. When pasting wallpaper, remove the panel of switch and socket

98. The bright and mercerized emulsion paint should be completed at one time, and the color difference is easy to appear

99 After the skirting line is installed, fill the seam with putty and emulsion paint

100. The frosted glass should be protected with newspapers

长春男科医院

杭州妇产医院

济南血管瘤医院

成都哮喘医院